查看“RichmondHolleman556”的源代码

When you begin studying for your CCNA and CCNP tests, many books can have you with a huge list of keystroke shortcuts for use on Cisco routers. Whilst the 640-801, 811, and 821 tests may ask you about a couple of of these, you obviously have to obtain hands-on experience with these commands to perfect them. Even better, there are some key combinations that Cisco routers note, but do not inform you what they're! Let us conclude with the "secret" method to stop a ping or traceroute, and take a look at a number of the more beneficial important combinations. 

The up arrow in your keyboard is great for repeating the past command you entered. Let's say you mis-enter an access-list. As opposed to typing it from the beginning, only hit your up arrow to repeat it, then fix the problem. 

CTRL-A requires the cursor to the start of a typed line. You know that can be quite a lengthy command, if you have written a protracted ACL, and one you probably do not want to retype. Use your up arrow to repeat the command, if you obtain a carat suggesting there's an issue with the point. If you see the error is near the beginning, use CTRL-A to go the cursor straight away to the beginning of the line. CTRL-E takes the cursor to the end of a typed line. 

To go the cursor through a typed line without erasing figures, you've got a couple of options. I know want to use the left and right arrows, however, you can also use CTRL-B to move straight back and CTRL-F to move forward. 

Finally, there is the combination that Cisco describes to you when you run ping or traceroute, but they don't tell you what it's! If you send an extended ping or even a traceroute, you could possibly be looking at asterisks for quite a long time if you do not know this one. In the following case, a traceroute is clearly failing: 

R2#traceroute 10.1.1.1 

Type escape sequence to abort. 

Tracing the approach to 10.1.1.1 

1 * * * 

2 * 

The problem is that you're likely to get 30 lines of those asterisks, which will be frustrating and time-consuming at the same time frame. Observe the router console information "Type escape sequence to abort." That is useful - but what is it? 

Here it is: Just sort CTRL-SHIFT-6 twice, once following the other. You will perhaps not see any such thing on the router console, nevertheless the traceroute will end. 

R2#traceroute 10.1.1.1 

Type escape sequence to abort. 

Tracing the approach to 10.1.1.1 

1 * * * 

2 * * * 

3 

R2# 

The traceroute was effectively terminated. This mixture works for pings as well, both prolonged and frequent. Of all the keystrokes you can learn, that one could be the most valuable! [http://www.landstarok.com/ tulsa new homes]